Re: New owner mk2s
You seem to be printing a bit too high. Have you done the calibration print and adjusted the Z height?
Nigel
Life is keeping interested and excited by knowledge and new things.
Re: New owner mk2s
Much better than my first prints 🙂
But as Nigel said, you need to adjust your Live Adjust Z.
This post might help:
Any advices given are offered in good faith. It is your responsibility to ensure that by following my advice you do not suffer or cause injury, damage or loss. If you solve your problem, please post the solution…
Re: New owner mk2s
Thanks for the feedback and the link. I did all the cal, and the z thickness gcode cal. I thought I had it putting out a not to thin not to thick path, but I do recalling struggling to identify the proper thickness a little
Re: New owner mk2s
Looks good... try slicing a Benchy.
Any advices given are offered in good faith. It is your responsibility to ensure that by following my advice you do not suffer or cause injury, damage or loss. If you solve your problem, please post the solution…