Notifications
Clear all
New Owner, Just finished build. Reset to 0,0,0
Hello,
I just did the preheat and the reset home to 0,0,0.
Everything works as it should but the print nozzle lands in the exact corner of the bed (past the glass vertically). I assume it should rest on the glass bed with the width of the included card yes? How can I fix this? Is there an adjustment that I can do?
Thanks!
Posted : 21/01/2016 7:05 am
Re: New Owner, Just finished build. Reset to 0,0,0
Hi Eric
Please refer to this post: http://shop.prusa3d.com/forum/prusa-i3-kit-building-calibrating-first-print-main-f6/problem-with-initial-auto-home-calibration-t513.html#p3613
Peter
Please note: I do not have any affiliation with Prusa Research. Any advices given are offered in good faith. It is your responsibility to ensure that by following my advice you do not suffer or cause injury, damage…
Posted : 21/01/2016 10:18 am