Issues with Z motors when Upgrading Mk1 (rambo 1.3a) --> Mk2S
Hi Everyone,
I've been reading the forums for a while but havent posted much.
Ran into a few troubles with my recent upgrade on my mk1.
I purchased an upgrade kit locally to get my Mk1 ->> Mk2s
- all Motors
- Upgrades parts
- smooth rods
- u bolts
- mk42 heatbed
- pinda probe
- E3D Full V6 hotend (from E3D) heater, thermistor, etc
Physically everything fit perfectly. Screen seems a bit dimmer/different than my other mk2s but very close overall.
I flashed the latest firmware (1_75mm_MK2-RAMBo13a-E3Dv6full.hex) for the mk2 with the rambo 1.3a, however my Z axis motors barely move once assembled. If they are free, no issues.
Im guessing this has to do with the current being fed to the motors, is there a way to update the settings ? I thought the new firmware would have that taken care of.
I have a second machine (mk2s) so i was able to test the motors, no issues when hooked up to that machine.
Any help would be greatly appreciated.