Benachrichtigungen
Alles löschen
FW 3.0.3 and MK1 fan doesn't stop
Dears, After updating my MK1 with 3.0.3 i have noticed that back fan doesn't stops after printing ends.
It is strange because in previous FW version everything was fine.
1. if i put STOP print - fans stopped
2. if printing goes till the end then hotted fan stops, back fan (nozzle one) keeps going.
it is for preloaded PRUSA codes also , not only mine. And before it was OK.
Please help )))
Veröffentlicht : 01/07/2016 9:33 am
Re: FW 3.0.3 and MK1 fan doesn't stop
Yury
Add the following line to the "End GCode":
M107
Peter
Please note: I do not have any affiliation with Prusa Research. Any advices given are offered in good faith. It is your responsibility to ensure that by following my advice you do not suffer or cause injury, damage…
Veröffentlicht : 01/07/2016 11:33 am