Notifications
Clear all

Clumping & 9 Point Calibration Issues  

  RSS
3D Print Solutions
(@3d-print-solutions)
Active Member
Clumping & 9 Point Calibration Issues

Hi All,

I have not long received my MK2 and i'm having some issues with it.

Firstly, the 9 point calibration that runs before each print seems to fail a lot, on the 3rd or 4th point with the message 'Debris on Nozzle?' There isn't anything on the nozzle and if I start again it often works (sometimes takes a few attempts)

The bigger issue at the moment is that i started a print yesterday, the first few layers set fine so i went to bed and woke up to a massive clump of filament stuck to the nozzle (pictures attached)

At this stage i really have no idea how to clean it up, it is all over the cables and everything and i can't preheat the printer, it says min temp error.

hoping someone can help.

Posted : 31/03/2017 2:01 pm
Share: