Notifications
Clear all
Page 2 / 2
Prev
Re: Bridge help needed in KISSlicer
Look on the "Support" tab, top right.
The pillar is just a thin-wall cylinder used to prime the extruder at the start of each layer; it can also be used to effectively slow the layer down while the plastic cools.
Try turning it on, slicing a model and the selecting Models+Paths; move the thumb up and down, you will see that is generated.
Peter
Please note: I do not have any affiliation with Prusa Research. Any advices given are offered in good faith. It is your responsibility to ensure that by following my advice you do not suffer or cause injury, damage…
Posted : 03/01/2016 5:15 pm
Topic starter
answered:
Re: Bridge help needed in KISSlicer
Thanks!
Posted : 03/01/2016 6:03 pm
Page 2 / 2
Prev