Notifiche
Cancella tutti
Watch out with your Prusa filament spools
Just had a nasty surprise ...
I have an enclosure whereby my filament sits on top of it and is fed through the side of the enclosure to my MMU.
I was printing with Prusa grey PLA when I ran out of filament. Instead of just pulling the last part of filament from the spool, the end of the filament is bent so it stays stuck to the spool. So what happened? The printer pulled the spool from the spool holder. It fell against the wall where of course it got stuck and the printer pulled itself to the right hand side in my enclosure 😯
Postato : 02/04/2018 9:39 pm