Notifications
Clear all

Thicker lines when layer fill meets  

  RSS
cory.w
(@cory-w)
Estimable Member
Thicker lines when layer fill meets

I keep noticing this problems after multiple recals or settings changes for various reason. During my first few solid layers, when the printer fills in the solid layer, it obviously jumps around in sections because it cant always fill in during one sequence. What I notice is, it will do one area, leaving half open, but when it comes back to do the other side, the final line is always a bit thicker.

You can notice this twice in the picture here. Not super good quality because its a screen grab from my octoprint cam. Not at home so couldnt take a real photo.

I've seen this anytime I have a big print like this.

Posted : 07/05/2017 7:46 pm
Share: