Notifiche
Cancella tutti
Thermal runaway, Slic3r and bridge
Hi all,
Just had some issues with a part printing high temperature 240C PETG Prusa settings. ones the first 3 layers are done the infill pattern is printed. Right after that the next full layer is printed as a bridge. The Prusa settings for bridge fan speed is 255 (Maximum). This resulted in the nozzle temperature drop for more then 15°C for more than 45 seconds and engages the Thermal runaway.
I have now changed the "bridges fan speed" to 50% end all is fine now 🙂
Postato : 07/11/2016 12:01 pm