Notifications
Clear all
Simplify3D surface on infill has hoes - filament is forfeited to infill
I'm trying Simplify3D and I have a problem, in Slic3r, under surface area in model, Slic3r generates some "infill support", that supports this surface and can be printed, but in Simplify3D, there isnt this support, and new fillament surface, printed on infill, will not stick in every corner due to infill holes, and then filament is forfeited down.
photos in attachements.
Is there any setting or solution for simplify3d?
thanks
Lubos
Opublikowany : 09/09/2017 3:20 pm