Notifications
Clear all
Simple parts: Cura with no zhop better than PE Slic3R?
Hello,
For simple parts like screw brackets it seems like slicing with Cura would have advantages vs. slicing with PE Slic3R with ZHops because it would reduce movements on the z axis, especially if printing multiple parts. Thoughts?
Thanks,
David
Posted : 04/01/2017 5:56 pm
Re: Simple parts: Cura with no zhop better than PE Slic3R?
You can always use the "ColourPrint" profile to slice without Z-Lift.
Peter
Please note: I do not have any affiliation with Prusa Research. Any advices given are offered in good faith. It is your responsibility to ensure that by following my advice you do not suffer or cause injury, damage…
Posted : 04/01/2017 7:47 pm
Topic starter
answered:
Re: Simple parts: Cura with no zhop better than PE Slic3R?
Cool, I will give that a try. Thanks for the info.
Posted : 04/01/2017 8:13 pm