Notifications
Clear all
Rough Sides - Printer Settings
So I built my first Mk3 over the weekend and ran a test print yesterday. I'm pretty pleased with the results of the first print, I did notice some rough patches on the sides of the print and was wondering what I could do to get rid of it and improve the quality. I am using the PLA that comes with the printer and the print was done with a bed temp = 60c and a hot end temp = 210 (standard DETAIL setting from PrusaControl). i have attached photos of the print. Any other suggestions are also appreciated!
- K
Opublikowany : 13/02/2018 3:54 am