Notifications
Clear all
Rough Corners on top layer
Hi Everyone!
I had just printed this model and I am getting these rough corners on the top layers. I double-checked the first-layer calibration and that looks good. Could this be an issue with the internal fill pattern or over-extrusion? When it started putting the top layers onto the gyroid fill, parts of the gyroid fill seemed to be sticking up and causing bumps. Any suggestions would be great!
Print Settings
.15mm Quality PLA
15% infill
Gyroid internal fill pattern
Rectilinear top and bottom fill pattern
First layer height .2mm
Opublikowany : 26/04/2020 2:52 pm