Printing using bioFila

Page 2 / 2 Précédent

Dernier message

RSS

cristian.s

(@cristian-s)

Trusted Member

Re: Printing using bioFila

I had the same experience recently with Biofila Platec Jet black. Layer adhesion really bad, like nothing I have ever seen before. I emailed them recently but it seems they are in a process of rebuilding their site and maybe more(the Two Bears company).

I've given up on it as a replacement for PETG/ABS for now. Even the 3D benchy was awful in strength.

Publié : 12/03/2018 9:46 am

Page 2 / 2 Précédent

Statistiques du forum

559 Forums

63 K Sujets

443.6 K Messages

22 En-ligne

67.9 K Membres

Le dernier des messages: Bare metal build plate for XL? Notre nouveau membre: etiennep Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé