[Fermé] Printing 16 of one object at a time

Dernier message

RSS

chukie

(@chukie)

New Member

Printing 16 of one object at a time

printing 16 clips at a time. If one of those goes bad can i some how skip it from printing ? I thought I seen you could some where but i con find it now Thanks again

Publié : 24/01/2020 7:30 pm

ron

(@ron)

Estimable Member

RE: Printing 16 of one object at a time

The only way i know is by printing from octoprint. Install the plugin octoprint-cancelobject and tick label in output of the print parameters of prusaslicer.

It works also for non identical parts.

Publié : 24/01/2020 8:20 pm

Statistiques du forum

565 Forums

63.6 K Sujets

446.3 K Messages

19 En-ligne

69 K Membres

Le dernier des messages: My XL is now called Sir Clog-a-lot after upgrades. Any ideas? Notre nouveau membre: twh344 Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé