Notifications
Clear all

Printer or Slicer at fault?  

  RSS
mark.w
(@mark-w)
New Member
Printer or Slicer at fault?

Been trying to print the 3Dlabprint Spitfire but as you can see from the pictures I am having serious quality issues... Can anyone advise what is going on and how to correct it....

Posted : 28/01/2017 11:35 pm
Wirlybird
(@wirlybird)
Reputable Member
Re: Printer or Slicer at fault?

What I see in the pics are the start and stop point seams for the layers. Pretty much unavoidable but can be reduced by settings. There are different things to try. Which slicer?
Others on here I am sure will have good advice depending on the slicer.

Posted : 30/01/2017 9:27 pm
Share: