Perimeter Defects

Ultimi post

RSS

andersonta

(@andersonta)

Eminent Member

Perimeter Defects

Anyone else have this issue with their perimeters? Extruder is not skipping during prints, flows just fine, and temps are good. Using mostly stock Slic3r settings.

?dl=0

Postato : 01/11/2015 8:41 pm

andersonta

(@andersonta)

Eminent Member

Topic starter answered:

Re: Perimeter Defects

Well, turns out its just bad temps. I always jump to some sort of mechanical issue way before thinking it might be a simpler, software related issue.

Printing the lime green PLA at 220C now, getting much better results. No more surface defects and much more consistent Z.

Postato : 03/11/2015 6:53 am

Statistiche Forum

566 Forum

63.1 K Discussioni

444 K Post

21 Online

68.1 K Utenti

Post recenti: "Filament stuck" errors every 15 seconds. Ultimo utente registrato: etiennep Post recenti Post da leggere Etichette

Icone forum: Il forum non contiene post non letti Il forum contiene post non letti

Icone discussione: Nessuna Risposta Con risposte Attivo Hot In evidenza Disapprovato Risolto Privato Chiuso