Notifications
Clear all

Perimeter Defects  

  RSS
andersonta
(@andersonta)
Eminent Member
Perimeter Defects

Anyone else have this issue with their perimeters? Extruder is not skipping during prints, flows just fine, and temps are good. Using mostly stock Slic3r settings.

?dl=0

Posted : 01/11/2015 8:41 pm
andersonta
(@andersonta)
Eminent Member
Topic starter answered:
Re: Perimeter Defects

Well, turns out its just bad temps. I always jump to some sort of mechanical issue way before thinking it might be a simpler, software related issue.

Printing the lime green PLA at 220C now, getting much better results. No more surface defects and much more consistent Z.

Posted : 03/11/2015 6:53 am
Share: