Notifications
Clear all
My #1 tip
Use that ABS spray. I refused to use it thinking it would end up being an extra printing cost, but it is downright needed. My prints would otherwise have defects in the first layer and the rest of the print.
I think it is saving me money in the long run considering I am wasting less filament on bad prints.
Publié : 04/07/2015 1:27 am
Re: My #1 tip
💡 You can easily mix your own spray, you just buy acetone in local HW store and mix it with ABS filament. The recipe is printed out on the bottle 😉
Do you have any prints to show off already?
Founder and owner / Majitel a zakladatel
Publié : 04/07/2015 5:42 pm
Topic starter
answered:
Re: My #1 tip
I do! Will post in appropriate thread.
Publié : 04/07/2015 8:41 pm
Re: My #1 tip
I like the Juice too
Publié : 09/07/2015 4:26 pm