Avisos
Vaciar todo
MK2S bearings very noisy
The bearings on the X-Axis of the MK2S are very noisy. Printing time is about 4 hours.
Is there any word or support for this?
Anyone else?
Respondido : 04/05/2017 5:40 am
Re: MK2S bearings very noisy
X and Y seems to work well. Z is quite noisy....right side cracking while moving up and down. Was trying to position the rods perfectly prallel but it didn't improve.
Respondido : 04/05/2017 6:28 am
Re: MK2S bearings very noisy
Hello,
I think , If your belt is too tight that make the the motor noisy,
Regard.
Respondido : 11/05/2017 3:59 am