Notifiche
Cancella tutti
Lines on Perimeter
My prints are starting to look better. This time, noticed a little bit of over extruding, looks to be at the start of the perimeter line. I did a temp bridge with this filament already and it hopefully isn't a temp issue. Also still getting thicker lines on solid layers where the second part of a layer meets up with whats already been done. Essentially it overlaps but by a lot.
Any advice on modifications?
Postato : 09/05/2017 2:34 am
Re: Lines on Perimeter
The belts might be too lose.
Postato : 12/05/2017 4:35 am