Notifications
Clear all

KISS vs Slic3r  

  RSS
jake.l
(@jake-l)
Active Member
KISS vs Slic3r

I downloaded KISS and Slic3r from http://www.prusa3d.com/drivers/ . Used the normal settings on each to print a 50mm tower. Here are the results (Slic3r is on the left, KISS on the right):

http://imgur.com/a/ZhWXY

Posted : 28/07/2015 5:28 pm
Josef Průša
(@josef-prusa)
Member Admin
Re: KISS vs Slic3r

With small objects like this, always try to print more at a time, it will get much better. The plastic doesn't have enough time to cool down before printing another layer. 💡

Founder and owner / Majitel a zakladatel
Posted : 04/08/2015 3:55 pm
Share: