Avisos
Vaciar todo
First Layer Blobs
Printing with Prusa PETG and using Prusa Slicer. I did not change any of the slicer settings. The first layer starts out pretty good but then there are blobs and thick spots in areas. Any ideas what could be causing this? I have not experienced this issue yet and did do a first layer calibration. Pic attached. Thanks
Respondido : 24/09/2019 4:11 am
RE: First Layer Blobs
moist filament or dirty sheet
Respondido : 24/09/2019 4:30 pm
RE: First Layer Blobs
Or too low a live z height so that it’s pushing filament ahead of the nozzle which builds up into ridges etc. Have you used the live z adjust method rather than the built in z adjust ?
Respondido : 24/09/2019 5:24 pm
Richard me gusta