Notifications
Clear all
Corner issue
Im printing parts for an ikea lack enclosure. This one:
https://www.thingiverse.com/thing:1843235/#files
My issue is with the corners of the lack foot. Please look at the model in thingiverse 3D viewer so you understand how its being printed. There are support walls on 2 sides, and there is support in the bottom third. The center section is being printed with 20% infill. The top is hollow.
The corners of the part where there is internal infill, look pretty jagged. I already increased the number of external perimeters from 2 to 5 but it makes no difference.
Im printing this in PLA, 0.3mm layer height and pretty slow. Im not sure whats going on here. Any thoughts?
Napsal : 24/08/2017 9:34 am