[Fermé] Cleaning up string with a heat gun?

Dernier message

RSS

Matt Boyer

(@matt-boyer)

Estimable Member

Cleaning up string with a heat gun?

I've run black PETG parts over a lighter to clean up string with great success. I've also sooted PLA parts doing that. Question is what would happen if I tried running Silk PLA parts under a heat gun? It was a 14 hour print so I'm not eager to experiment and screw it up.

Publié : 06/06/2020 2:58 am

bobstro

(@bobstro)

Illustrious Member

RE: Cleaning up string with a heat gun?

Just use a light touch. Practice on a few smaller parts to get used to it. I use a heat gun with PLA and PETG without any problems.

My notes and disclaimers on 3D printing

and miscellaneous other tech projects
He is intelligent, but not experienced. His pattern indicates two dimensional thinking. -- Spock in Star Trek: The Wrath of Khan

Publié : 06/06/2020 5:02 am

Statistiques du forum

565 Forums

63.5 K Sujets

445.7 K Messages

19 En-ligne

68.7 K Membres

Le dernier des messages: Déformation pièce/problème filetage Notre nouveau membre: Frickelfred Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé