Blobs
On a few prints I am finding blobs.
If I am printing a tube with the middle being hollow. It prints 3 layers wide but the middle is blobs. This then causes the outside layers to look bad.
Am I making a rookie mistake here and the blobs are some sort of infill? 😳 I use Slic3r
Re: Blobs
Ben
A photo would help...
Blobs may indicate that you need to calibrate your extrusion or they may be to do with the seam and you need to adjust the "seam hiding" parameters. Could also indicate insufficient retraction when moving the nozzle or something else.
Peter
Please note: I do not have any affiliation with Prusa Research. Any advices given are offered in good faith. It is your responsibility to ensure that by following my advice you do not suffer or cause injury, damage…