Notifications
Clear all
Small bubbles on build plate
Just got the MK3 a couple of weeks ago I have notices small bubbles starting form on the surface of the build plate. Is this normal? Printing with PLA 200-210c extruder 60c bed. Sorry if this has already been covered.
Thanks
Publié : 21/02/2018 1:32 pm
Re: Small bubbles on build plate
my build plate does the same thing.
Publié : 21/02/2018 1:36 pm
Re: Small bubbles on build plate
It is normal, just flip it over for a few prints - I have seen the bubbles disappear.
Publié : 21/02/2018 1:57 pm
Topic starter
answered:
Re: Small bubbles on build plate
Thanks for the replies.... good to know!
Publié : 21/02/2018 2:03 pm
Re: Small bubbles on build plate
I think you could prevent bubbles from appearing if you always wait until the sheet has fully cooled down before removing the printed object! Because the glue under the PEI gets soft when it is warm
Publié : 21/02/2018 2:52 pm