Notifications
Clear all

Small bubbles on build plate  

  RSS
michael.r51
(@michael-r51)
New Member
Small bubbles on build plate

Just got the MK3 a couple of weeks ago I have notices small bubbles starting form on the surface of the build plate. Is this normal? Printing with PLA 200-210c extruder 60c bed. Sorry if this has already been covered.

Thanks

Posted : 21/02/2018 1:32 pm
RobertB67
(@robertb67)
Trusted Member
Re: Small bubbles on build plate

my build plate does the same thing.

Posted : 21/02/2018 1:36 pm
stahlfabrik
(@stahlfabrik)
Honorable Member
Re: Small bubbles on build plate

It is normal, just flip it over for a few prints - I have seen the bubbles disappear.

Posted : 21/02/2018 1:57 pm
michael.r51
(@michael-r51)
New Member
Topic starter answered:
Re: Small bubbles on build plate

Thanks for the replies.... good to know!

Posted : 21/02/2018 2:03 pm
stahlfabrik
(@stahlfabrik)
Honorable Member
Re: Small bubbles on build plate

I think you could prevent bubbles from appearing if you always wait until the sheet has fully cooled down before removing the printed object! Because the glue under the PEI gets soft when it is warm

Posted : 21/02/2018 2:52 pm
Share: