Slic3r Profile Oddities

Dernier message

RSS

Peter L

(@peter-l)

Honorable Member

Slic3r Profile Oddities

I've noticed a couple oddities about the Slic3r profiles included for the MK3. Curious to know if anyone has any insight into the logic of these settings:

The first layer extrusion width is smaller than the default extrusion width in the standard profiles. I would have expected it to use a fatter-than-normal extrusion on the first layer for better adhesion.

The first layer temperature for the PETG profile is cooler than other layers. I would have expected warmer extrusion on the first layer to improve adhesion.

Anyone know why Prusa uses these settings?

Publié : 27/02/2018 7:13 pm

Statistiques du forum

559 Forums

62.2 K Sujets

439.8 K Messages

18 En-ligne

67.6 K Membres

Le dernier des messages: Extruder macht nur Laufgeräusche und fördert nicht. Notre nouveau membre: StepOnItNow Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé