QC Issue and question on threading

Dernier message

RSS

AlexU

(@alexu)

New Member

QC Issue and question on threading

Just wanted to let you know about a QC issue I've had with the MK3 kit. One of the short lengths of aluminum extrusion was missing the M5 threading. Not a big deal as I can just buy a tap and thread it myself.

What I wanted to check is the threading. M5x0.8?

edit: I have confirmed that the threading is M5x0.8.

Publié : 20/03/2018 9:03 pm

Statistiques du forum

566 Forums

63.2 K Sujets

444.2 K Messages

21 En-ligne

68.1 K Membres

Le dernier des messages: M112 error when sending gcode from Octoprint to MK3.5S but prints fine from USB stick Notre nouveau membre: etiennep Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé