I3 mk3 over extruding
Hi forum.
I recived my assembled Prusa i3 mk3 a cuople of weekes ago. Right away i noticed over extrusion issues.
I have updated to the lates firmware and ran calibration and self test, i now have two issues.:
1. Filament sensor fails self test and says "ERROR: Filament sensor not responding, please check connection".
2. After updating firmware i have massive over extrusion issues.
I'm using prusa control as a slicer. I am not used to this slicer (Used Cura for 6 years). What should i do to correct the over extrision issue and anyone else having problems with their filament sensor on pre assembled mk3's`
Re: I3 mk3 over extruding
Post a picture of your "massive" over extrusion. We can't help if we can't see it.
Re: I3 mk3 over extruding
Roger that.
The blue one was printed on my UM2. They grey one on my mk3.
The grey one weighs i great deal more than the blue one so i'm pretty sure it is over extrusion, allthough it looked like under extrusion at first glance.
