Notifications
Clear all
Extruder clog?
😯
This happened relatively early on during a print after I walked away. What happened? and what steps should I take to correct this problem and prevent it from happening again?
Posted : 14/02/2018 6:00 pm
Re: Extruder clog?
to remove a clog, prusa uploaded a video.
To prevent you will have to figure out what went wrong.
Posted : 14/02/2018 6:20 pm
Re: Extruder clog?
I suspect your print failed to stick to the bed and a clump stuck to the nozzle.
Always watch layer 1.
Posted : 14/02/2018 6:30 pm