Notifications
Clear all
Unload/load filament tweaks (auto heatup)
Just a small tweak that would save some time. When going to the menu and selecting unload filament - if the extruder is not being heated then auto heat it up to 180 (adjustable maybe?) and then begin the unload. Once unloaded auto set the temp to 200 (again adjustable?) and have the user load filament.
The reason for the lower temp on unload is to reduce the stringing of some filaments.
Napsal : 12/11/2017 9:36 pm
Re: Unload/load filament tweaks (auto heatup)
this could lead to complaints for ABS, PETG, Nylon and other high temperature filaments!
regards Joan
I try to make safe suggestions,You should understand the context and ensure you are happy that they are safe before attempting to apply my suggestions, what you do, is YOUR responsibility. Location Halifax UK
Napsal : 13/11/2017 2:46 am