System that allows to stop printing automatically when the part separates from bed During Print
 
Notifications
Clear all

System that allows to stop printing automatically when the part separates from bed During Print  

Strona 2 / 2
  RSS
3d-gussner
(@3d-gussner)
Reputable Member Prusa-Translations
Re: System that allows to stop printing automatically when the part separates from bed During Print

Hi,

got finally the new 3.1.0-RC2 firmware for Prusa i3 MK2/S/MMU with Hyperfine Bed Tuning and Filament Runout Sensor tested and released.
Check my github https://github.com/3d-gussner/Prusa-Firmware/releases for the latest version.

Opublikowany : 08/11/2017 9:50 am
stefan.w5
(@stefan-w5)
Active Member
Re: System that allows to stop printing automatically when the part separates from bed During Print

This thread really has gone off-topic - only the first two posts are talking about a "system that allows to stop printing automatically when the part separates from the bed during print".

After that it somehow changed around completely, to detecting when the printer runs out of filament (which is much much easier, and for which a thread already exists), and has been about that topic ever since.

The topic should probably be split. That the firmware changes (previous post) with the Filament Runout Sensor apply to both threads just show how off-topic this one has gone.

Opublikowany : 11/11/2017 5:58 pm
Strona 2 / 2
Share: