Benachrichtigungen
Alles löschen
Has anyone tried Magigoo?
Hi,
I heard about this: http://thought3d.com/magigoo/
I was wondering if anyone tried it and how it works with the PEI sheet found on the MK2's bed.
Veröffentlicht : 12/08/2016 4:55 pm
Re: Has anyone tried Magigoo?
Personally, I haven't had any adhesion problems with my PEI sheet, but I also haven't used much other than PLA or PLA/PHA on my printer yet. I did get some POM, ABS, PP, and a few other filaments. I just haven't tried them yet.
Dimensions PNG
and an 8 inch (200mm) or greater caliper is recommended.
Veröffentlicht : 13/08/2016 8:30 am