Avisos
Vaciar todo
zero thickness top and bottom layers?
This airplane wing model mentions printing with zero top and bottom thickness.
I think the idea is the slicer will generate the internal wing structure, and for light weight the wing is covered with tape.
What slic3r settings would I use to set the top and bottom layer thickness to zero?
Respondido : 30/05/2018 7:55 am
Re: zero thickness top and bottom layers?
Hi Mark
good question...
I have never really looked
Horizontal shells, just below middle of the page, shown above
regards Joan
I try to make safe suggestions,You should understand the context and ensure you are happy that they are safe before attempting to apply my suggestions, what you do, is YOUR responsibility. Location Halifax UK
Respondido : 30/05/2018 10:43 am
Topic starter
answered:
Re: zero thickness top and bottom layers?
Thanks Joan, much appreciated!
Respondido : 31/05/2018 5:17 am