Warping even with a Brim

Dernier message

RSS

Karl

(@karl)

Active Member

Warping even with a Brim

My 1st layer is good on the calibration, when i go to print i get warping even with a brim.. PLA

Publié : 24/03/2019 11:04 am

JoanTabb

(@joantabb)

Veteran Member Moderator

Re: Warping even with a Brim

what filament? temperatures, settings?

I try to make safe suggestions,You should understand the context and ensure you are happy that they are safe before attempting to apply my suggestions, what you do, is YOUR responsibility. Location Halifax UK

Publié : 24/03/2019 11:20 am

Statistiques du forum

566 Forums

63.2 K Sujets

444.3 K Messages

22 En-ligne

68.1 K Membres

Le dernier des messages: First layer of some objects *sometimes* gets 'engraved' into the smooth PEI Sheet (PLA) Notre nouveau membre: etiennep Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé