TREED Carbonium settings for Slic3r?
After reading about the TREED Carbonium filaments in this thread:
https://shop.prusa3d.com/forum/awesome-prints-hall-of-fame--f15/carbon-fibre-t23927.html
I ordered a roll of Carbonium PETG and Carbonium Nylon, and a 0,6mm hardened E3D Nozzle.
I have spent several evenings trying to print with the Carbonium PETG so far, but with very limited success.
Despite increasing the temperature to 275 °C (Treed recommends 230-250 °C) I am struggling with clogged nozzles.
I have described my experiences in this and the following posts: https://shop.prusa3d.com/forum/awesome-prints-hall-of-fame--f15/carbon-fibre-t23927-s40.html#p115147
If you have printed successfully with any of the TREED CARBONIUM filaments, I'd greatly appreciate if you could share your config files and experiences!
Re: TREED Carbonium settings for Slic3r?
Bump! Anyone printed with these materials successully?