Avisos
Vaciar todo
TPU print
Hi, I've got issues with TPU print with my new mk3, it wasn't the same with the mk2. The filament jump away just under the Bondtech. It folds. Thanks.
Respondido : 19/10/2018 6:03 pm
Re: TPU print
Guessing here but...TPU can not have any resistance in the filament path after the extruder. If it is just below the gears I would think a bit of a jam in or at the opening of the PTFE tube. Maybe a smidge out of round or rolled in from putting it in its place.
Hope that helps,
Neal
Respondido : 19/10/2018 6:45 pm