TPE won't stick to Printbed...  

RE: TPE won't stick to Printbed...

Print Settings TPE 90A

Here are the settings I used. Please check them, compare to the default, and decide for each whether to use it or not.

I think the huge brim was the most important change.

RE: TPE won't stick to Printbed...

Thanks Christian! I was finally able to get a good print out of this filament with your params. Printing in the PEI sheet it sticks quite nicely, the only issue I can find is the massive brim being part of the piece. I'll tinker with the config a bit, if I find a way around the brim I'll post it here.

TPE params

Hi Christian

Could you please reshare the params for this filament - for some reason they are stripped from your original post - having exactly the same issues.Tried Magigoo Flex but it really did not do a lot of good.

Thx

Settings

Hi PetHar,

Sorry for my late reply. I hope it is still helpful.

In my memory, the most important setting was a huge brim (e.g. 20mm) and I am not sure right now if that is included in the settings that I uploaded.