Avisos
Vaciar todo
top layer "elephants foot"
Hi everybody,
I seem to have some settings wrong...
No matter what and with what I print I do get some degree of top layer overhang. Pretty much looking like the elephants foot just upside down.
Z-calib is done with the 75x75mm sheet and looks quite good finally. Also using the 7x7 mesh bed levelling, which improved first layer quality significantly. I first thought it might be some warping effect with ASA but on closer inspection PETG (Prusament), PLA (Prusa standard) and Taulmann t-glase all have the same artifact. Rather annoying I have to say.
Any good ideas what might need tweaking here?
Cheers
Hansjoerg
Respondido : 16/12/2019 11:40 pm