Tips printing Benchy
Hello everyone
Am busy printing the Benchy.
This is going pretty well. except for a few curves.
Seek help where and how to improve.
The Benchy is printed with PLA-195/60 degrees.
Do the same at 220/60 degrees with the same result.
We use the prusa slicer and print with Prusa 3S
Who has tips, or a perfect Benchy prusa-slicer file.
RE: Tips printing Benchy
I have the same issue. Did you find the right settings?
RE: Tips printing Benchy
Remember that the Benchy is considered pretty much a torture test and is intended to be somewhat of a challenge for a printer to do.
Having said that, looking at the above, the first thing that comes to my mind is damp filament, with the stringing and inconsistent extrusion.
The first thing I would do if this were mine is to do it again with a spool of fresh known-dry filament or else dry the current spool.
I've found that the defaults for PLA work best for 99.9% of the PLA filaments and prints.
RE: Tips printing Benchy
Thank you for your answer. I will try Dr my filament