Benachrichtigungen
Alles löschen
Shrunken first layer and sloping sides on small part.
Hi,
Any advice on how to eliminate a shrunken first layer and sloping sides on a small Prusa Vanilla White PLA part (see attached photo below of side view)? My setup is:-
Standard PrusaSlicer v2.2.0 Fillamentum PLA settings, e.g. layer height 0.1, first layer height 0.2, etc…
Standard settings changed to First layer temp 210 deg, other layers 205 deg.
0.25 nozzle
Print settings 0.1mm detail.
Any ideas?
Regards, Carl.
Veröffentlicht : 01/08/2020 11:14 am