Avisos
Vaciar todo

Rate My Prints - How to make better?  

  RSS
Mawzie
(@mawzie)
New Member
Rate My Prints - How to make better?

New MK3S+ came and I’ve been loving it and printing none stop. I’m at a point where I think the prints look pretty good, but have some minor adjustments needed to be perfect. 

My goal is to post some pictures and see if there’s any recommendations to make them better quality. 

Respondido : 25/01/2021 6:11 pm
cwbullet
(@cwbullet)
Miembro
RE: Rate My Prints - How to make better?

Pretty darn good,  No suggestions.  

--------------------
Chuck H
3D Printer Review Blog

Respondido : 27/01/2021 2:25 am
Mawzie
(@mawzie)
New Member
Topic starter answered:
RE: Rate My Prints - How to make better?
Posted by: @cwbullet

Pretty darn good,  No suggestions.  

Thanks for the response! I think I may have posted in the wrong thread.

Any thoughts on how to get the bridging on the Groot Flower Pot under the chin cleaner? 

Or also what causes the kind of messy look to the under side of the octopus? 

Respondido : 27/01/2021 2:32 am
RAH1
 RAH1
(@rah1)
Estimable Member
RE: Rate My Prints - How to make better?

Make that +1  VERY good job. 

I am the inveterate tinkerer. I can tink up most anything.

Respondido : 27/01/2021 5:10 am
Compartir: