Notifications
Clear all
Printing TPU on PETG without MMU
Hi there,
I searched a lot but didn't really found an answer. I want to print TPU on PETG. I want to switch the material and the settings once at a specific layer of the print. So the first part is printed with PETG and after the switch, the print finishes with TPU. Is there a possibility in the PrusaSlicer Software to configure this material switch like pausing the print, switch the material to TPU, ressume the print with TPU-settings.
Cheers from Switzerland
Tobi
Posted : 29/10/2019 2:41 pm
RE: Printing TPU on PETG without MMU
hi,
you can try this method:
It's a virtual mmu, so you can switch filaments with the specific k-factor and extrusion multiplier.
Posted : 29/10/2019 4:26 pm