Notifications
Clear all
Printing a chain or helix on MK3 with PLA
Folks,
Looking for guidance. I've been trying to print chainmail links or a twisted object using the MK3. I've added ramps and even supports but each time I print one or two pieces of the links get knocked loose from the ramps before I get too far into the process. I've tried slowing to 80 % speed but this is still a problem. I'm printing at 60% infill and .15mm resolution.
Any thoughts to help these pieces adhere and not get knocked over mid print?
Thanks,
Paul
Publié : 07/11/2018 4:16 am
Re: Printing a chain or helix on MK3 with PLA
you try a brim yet?
I have a Prusa,therefore I research.
Publié : 07/11/2018 6:01 am