Notifications
Clear all
Petg is warping and got layerlines
Hello everybody,
I am printing the prusa enclosure right now so I am printing a lot of Petg. I am printing on a texture print bed which I bought together with the filament from prusa.
I am getting warped edges on some prints but often not all edges just one or two.
I am also getting layers not sticking to another like they are warping in the middle of the print
I am using Standart prusament Petg setting with the only difference that I changed the first layer print Temperatur to the same as the rest 240°/90°.
I even sliced the one with the awful support again and added a brim.
I know the support looks awful but I think that this one is not that bad because it had nowhere to "hold on" on the other side.
Posted : 15/01/2023 3:12 pm