Notifications
Clear all
Only one corner UGLY - Printing PC
I've been trying to tune Priline Polycarbonate filament for a few days. This is a piece of a temp tower which shows the same artifact every time I print it. The remaining areas of the piece come out close to perfect; however, this one edge always builds up excess material, leading to the corner sloppiness you see, and a rolled lip at the top of the model.
I'm having no issues with bed or layer adhesion.
Thanks for any ideas!
Ce sujet a été modifié il y a 4 years par mavery
Publié : 08/10/2020 4:55 pm
Topic starter
answered:
RE: Only one corner UGLY - Printing PC
UPDATE: Oddly enough, the corner turns out ugly is dependent on orientation of the model during printing. I rotated 180 degrees on the XY plane, reprinted, and the ugly corner is now on the opposite site as you can see.
Publié : 08/10/2020 5:32 pm
RE: Only one corner UGLY - Printing PC
I believe this is a part cooling fan issue
Publié : 15/01/2021 8:05 pm