Need Help
As of this week I have had the worst luck getting any of my prints to come out right.
I just printed with this filament last week, and that was well over 80 hours; no issues. However as of late, I can't get this to work anymore.
I have done the newest firmware and do the calibrations 4 times, done 3 cold pulls and switched filaments, and still getting this problem.
I have done a couple of temperature changes to see if that's it but Nope. It seems like its under extruding. I've loosen the bowden gears even, and still the same problem.
Matter Hacker Bronze Pro PLA
Nozzle 215-208C
Bed 50 C
0.2mm height
Mostly Stock settings
Matter Hacker Bronze Pro PLA
Nozzle 220-215C
Bed 50 C
0.2mm height
Mostly Stock settings
Maker Geek PLA
Nozzle 215-210C
Bed 50 C
0.2mm height
Mostly Stock settings
Re: Need Help
This the same filament as of last week
8hr print
Matter Hacker Bronze Pro PLA
Nozzle 215-210C
Bed 50 C
0.10mm height
Mostly Stock settings
