Notifications
Clear all

MMU3 infill  

  RSS
ZOHOZ
(@zohoz)
Active Member
MMU3 infill

I have a large print and I don’t have enough filament to do it, and I only have one roll. Is it possible to use the mmu to have a different color for the infill or supports?

Publié : 31/10/2024 4:14 am
Robin
(@robin)
Noble Member
RE:

Yes, but it will probably not solve your problem, because it will add a lot of material to the wipe tower (even with wipe to infill enabled)

Ce message a été modifié il y a 2 months par Robin

If at first you don't succeed, skydiving is not for you.
Find out why this is pinned in the general section!

Publié : 04/11/2024 3:32 pm
Partager :